View Single Post
Old 10-01-2012, 01:33 PM   #2
Senior Member
Join Date: Mar 2009
Location: Florida
Posts: 313

What happens if you change your PTT key to Command?

Also, Check #8 in the troubleshooting guide

finally if the above does not solve the issue:

If that doesn't work, do the following
  1. Restart your Mac
  2. Open Vent
  3. Go to setup by clicking the Setup button
  4. Make sure the first tab (Voice) is selected.
  5. Check the following checkboxes
    - Enable outgoing voice communication
    - Use Push-To-Talk Hotkey (PTT Mode) (if this is not checked it may ask you to configure universal access)
    - Click in the HotKey field and press the Command key on your keyboard (the field will then say command)
  6. Click OK
  7. Click the setup button again
  8. Click the Test button
  9. Press and release the Command key several times - noting any changes in the white tall box to the right of the Test button.

Click Test to end the test and then Click OK.

Give us the results of what appeared, if anything, in the list in the white box.
Jaycyn is offline   Reply With Quote