View Single Post
Old 02-05-2008, 02:01 PM   #3
fredag
Junior Member
 
Join Date: Feb 2008
Posts: 1
Default

Quote:
Originally Posted by binded View Post
Hello all,

Since the release of 3.0 i've been having difficulty connecting to any vent server.

I'm using a Cisco 4500 Router and so far I've done the following:

access-list 100 remark Vent
access-list 100 permit udp any any eq 6100
access-list 100 permit udp any any eq 5000
access-list 100 permit udp any any eq 3106 - Vent Server Port
access-list 100 permit tcp any any eq 3106 - Vent Server Port

I'm still hanging at MSG: Contacting Server.
Is acl 100 for incoming or outbound traffic?

Here is a working example for you:

sh running-config interface vlan XXX

ip address XXX.XXX.XXX.1 255.255.255.0
ip access-group 101 in
ip access-group 102 out

Now, in acl 101 you'll have to permit the outgoing traffic:
access-list 101 permit udp any any eq 6100
access-list 101 permit udp any any eq 5000
access-list 101 permit udp any any eq 3106

then, permit the incoming traffic in acl 102

access-list 102 permit udp any eq 6100 any
access-list 102 permit udp any eq 5000 any
access-list 102 permit udp any eq 3106 any

If you're using the same access list for bort incoming and outbound traffic you'll need something that permits traffic both ways, concatenate it into:


access-list 100 permit udp any any eq 6100
access-list 100 permit udp any any eq 5000
access-list 100 permit udp any any eq 3106

access-list 100 permit udp any eq 6100 any
access-list 100 permit udp any eq 5000 any
access-list 100 permit udp any eq 3106 any

Ventrilo does not use tcp btw.
fredag is offline